Can water damage air tools?
Short answer: Yes, water washes out lubrication and causes rust on vanes, cylinders and bearings, so drain tanks and filters and oil tools after exposure.
Yes. Water is one of the most common reasons air tools lose power and wear out early. Compressed air carries moisture, and when it reaches a tool it displaces the oil film the vanes rely on, then sits inside the motor and rusts the cylinder, vanes, bearings and hammer parts. Rusted vanes stick in their slots, and rough bearings make the tool noisy and slow.
Prevention starts upstream. Drain the compressor tank daily, use filters and a dryer, take drops off the top of the main line and drain the legs. If a tool has been exposed to water, put a few drops of air tool oil in the inlet and run it to drive the water out, then oil it again before storage.
Severely rusted tools may need a motor rebuild. Store tools dry and capped, and wear eye protection when first running a wet tool, since rust and debris can blow out of the exhaust.
Tools used for this job
General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.