How do I replace a belt on a belt-drive compressor?
Short answer: Disconnect power and lock it out, bleed the tank, remove the belt guard, loosen the motor mount to slacken the belt, fit the correct replacement belt, then set tension and pulley alignment before refitting the guard.
Always start by switching off and locking out power and draining tank pressure so the compressor cannot start while your hands are near the pulleys. Let the pump cool, since heads and lines get very hot.
Remove the belt guard and note how the motor is mounted. Most designs use a sliding base or adjustable bolts that let you move the motor toward the pump to remove the old belt. Match the replacement belt's size and profile to the old belt or the maker's part number; multi-belt drives should get matched sets.
Fit the new belt without prying it over the pulley edges, then move the motor back to set tension according to the manual. Check that pulleys line up with a straightedge.
Reinstall the guard before restoring power. Run the compressor briefly, then recheck tension after a few hours of use, since new belts stretch slightly. Wear eye protection and gloves.
General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.