Store relaunching soon · pro diagnostics & tools for independent shopsjoseph@directtoolsource.com
Direct Tool SourcePro Diagnostics
Home / Answers / Air Tools & Compressed Air / Body Shop Air Tools / How does a pneumatic door skinning tool work?

How does a pneumatic door skinning tool work?

Short answer: A pneumatic door skinning tool uses an air cylinder to squeeze the new door skin's flange over the door frame in controlled steps, giving a tighter, more even hem than hammer and dolly work alone.

When a door skin is replaced, the outer panel's edge must be folded, or hemmed, around the inner door frame. Traditionally this was done with a hammer and dolly in stages. Pneumatic hemming or door skinning tools use air pressure to drive a jaw that bends the flange progressively, first to an angle and then flat.

Work in short sections along the edge and follow the sequence the skin maker or vehicle repair manual recommends. Many repairs also use panel bonding adhesive in the hem, which must be applied before hemming and within its working time.

Protect the outer paint with tape on the jaws when recommended, keep fingers clear of the jaw and wear eye protection. Check the door's gap and body lines before the adhesive cures.

Last reviewed 2026-11-20 · Body Shop Air Tools

Tools used for this job

Astro Pneumatic DS1000 Pneumatic Door Skinning ToolAstro Pneumatic DS2000 Pneumatic Door Skin Removal Tool

General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.