Should I buy a straight or angle die grinder?
Short answer: Straight die grinders excel at porting, deburring and reaching into holes with burrs and stones, while angle die grinders hold surface conditioning discs and reach flat surfaces in tight spots; many shops own both.
A straight die grinder holds the collet in line with the body. It is the classic tool for carbide burrs, mounted stones and small flap wheels, and it reaches into bores, ports and deep areas. Technicians use it for deburring, enlarging holes, cutting off broken studs flush and cleaning up welds.
An angle die grinder turns the collet 90 degrees, often with a 1/4-inch collet or a quick-change disc holder. It is popular for surface conditioning discs that clean gasket surfaces, remove rust and prep for welding or sealing, and for reaching surfaces where a straight tool cannot sit flat.
If you buy only one, think about your work: engine and fabrication work favors straight, while brake, gasket and rust prep favors angle. Use accessories rated at or above the tool's free speed, and always wear eye protection, gloves and hearing protection.
Tools used for this job
General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.