Store relaunching soon · pro diagnostics & tools for independent shopsjoseph@directtoolsource.com
Direct Tool SourcePro Diagnostics
Home / Answers / Air Tools & Compressed Air / Shop Air for Diagnostics and Testing / What air supply does a cylinder leak-down tester need?

What air supply does a cylinder leak-down tester need?

Short answer: A leak-down tester needs a steady, clean shop air supply above its regulated test pressure, commonly around 100 psi at the inlet, with a quick coupler; the tester's own regulator sets the test pressure.

Leak-down testers feed regulated air into a cylinder at top dead center and compare the input with what the cylinder holds. Most testers use a regulator and two gauges, and they expect enough inlet pressure to hold the regulator setting steady throughout the test.

Use a filter on the supply so water and debris do not enter the cylinder. Many technicians set a standard test pressure recommended by the tester maker so results compare consistently.

The engine must be at top dead center on the compression stroke for the cylinder being tested. Air pressure can rotate the crankshaft suddenly if the piston is off TDC, so hold the crank with a wrench and keep hands clear of belts and fans.

Listen at the intake, exhaust, oil fill and radiator to identify where air escapes. Wear eye protection and keep the engine off and the ignition disabled during testing.

Last reviewed 2026-11-20 · Shop Air for Diagnostics and Testing

General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.