Why does my air ratchet leak at the head?
Short answer: Leaks at the head usually indicate a worn seal or gasket where the head joins the motor housing, or grease escaping from an overfilled or worn head; disconnect air and inspect the seals.
An air ratchet has two main areas where leaks show up near the front. Air hissing from the joint between the head and the motor housing usually means the seal, gasket or O-ring there is worn or that the head nut has loosened. Grease seeping from the head points to an overfilled head, worn seals around the anvil or a cracked head housing.
Disconnect air and check whether the head nut or screws are tight to the maker's specification. If they are, remove the head and inspect the seals and the mating surfaces for damage or debris. Replace worn seals with the maker's kit, clean the surfaces and reassemble. When re-greasing, use only the amount specified, since excess grease is pushed out under use and can attract dirt.
After reassembly, test for air leaks with soapy water while the tool is connected but not running. Replace a cracked head rather than trying to seal it. Wear eye protection while testing.
Tools used for this job
General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.