Store relaunching soon · pro diagnostics & tools for independent shopsjoseph@directtoolsource.com
Direct Tool SourcePro Diagnostics
Home / Answers / TPMS Service / TPMS Warning Diagnosis / How do I tell whether a TPMS problem is a sensor or the receiver module?

How do I tell whether a TPMS problem is a sensor or the receiver module?

Short answer: Trigger every sensor with a TPMS tool first; if all sensors respond with good data but the module still reports them missing, look at the module, receiver, antenna or learned IDs instead.

A TPMS tool tests the sensors from outside the tire. If a sensor does not respond to the trigger signal, or reports a low battery or implausible pressure, the sensor is the likely problem. Make sure the tool is set to the correct vehicle so it uses the right protocol, and try more than once before condemning a sensor.

If every sensor responds normally, read the TPMS module with a scan tool. Compare the stored sensor IDs to the ones you just read. Mismatched IDs mean a relearn was missed. Matching IDs with sensors still reported as "no signal" point toward the receiver, an external antenna on vehicles that use one, wiring, or interference from aftermarket electronics such as plug-in chargers, dash cameras or LED lighting.

Service information and code descriptions narrow it further. Some modules log separate codes for a missing sensor, a low battery, or an internal receiver fault, and those codes should guide the next test.

Last reviewed 2026-11-16 · TPMS Warning Diagnosis

Tools used for this job

Autel TS900 TPMS And Diagnostic TabletAutel 700150 MaxiTPMS ITS600Pro

General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.