Store relaunching soon · pro diagnostics & tools for independent shopsjoseph@directtoolsource.com
Direct Tool SourcePro Diagnostics
Home / Answers / Air Tools & Compressed Air / Air Ratchets / Why does my air ratchet only turn in one direction?

Why does my air ratchet only turn in one direction?

Short answer: If an air ratchet drives only one way, the reverse selector or the pawl and spring in the head are usually stuck, worn or installed wrong; cleaning and rebuilding the head normally fixes it.

Most air ratchets change direction with a selector knob or lever on the head that flips the pawl, not by reversing the motor. If the selector turns but the ratchet still drives the same way, the pawl may be stuck with old grease or debris, the pawl spring may be broken, or the selector detent may be worn.

Disconnect air and remove the head. Clean out old grease and inspect the pawl, its spring and the selector for wear or damage. Replace worn parts with the maker's head kit, apply the specified grease and reassemble with parts in the correct orientation. A pawl installed backward during a previous repair is a common cause after service.

On models where the motor itself reverses, a stuck reverse valve can cause similar symptoms, so check the manual for your design. Test the tool in both directions with a socket installed before returning it to service, and wear eye protection.

Last reviewed 2026-11-20 · Air Ratchets

Tools used for this job

Ingersoll Rand 1225-TRK1 3/8 Replacement Head Kit for 1225CalVan SG-101 M7 Lubrication Kit for Air Tools

General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.