Store relaunching soon · pro diagnostics & tools for independent shopsjoseph@directtoolsource.com
Direct Tool SourcePro Diagnostics
Home / Answers / Air Tools & Compressed Air / Air Ratchets / Why is my air ratchet slipping or skipping?

Why is my air ratchet slipping or skipping?

Short answer: Slipping usually comes from worn ratchet pawls, a weak pawl spring, worn yoke or anvil teeth, or dried-out grease in the head; a head rebuild kit usually fixes it.

The ratchet head uses a pawl and gear mechanism to turn the anvil one direction while allowing the yoke to swing back. When pawls or their springs wear, the mechanism skips, especially under load. Dried or contaminated grease can make pawls stick so they do not engage fully.

Disconnect air first. Many air ratchets have a serviceable head that comes apart with a few screws or a retaining nut. Clean old grease, inspect the pawl, spring, anvil teeth and yoke for wear, and replace worn parts with the maker's kit. Re-grease with the lubricant the maker specifies, in the amount specified, since too much grease can also cause problems.

Using the ratchet head as a breaker bar or cheater accelerates wear and can crack the head. Break tight fasteners loose with a hand tool first. If you are not comfortable rebuilding the head, a tool service center can do it. Wear eye protection when testing the rebuilt tool.

Last reviewed 2026-11-20 · Air Ratchets

Tools used for this job

Ingersoll Rand 1225-TRK1 3/8 Replacement Head Kit for 1225CalVan SG-101 M7 Lubrication Kit for Air Tools

General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.