Store relaunching soon · pro diagnostics & tools for independent shopsjoseph@directtoolsource.com
Direct Tool SourcePro Diagnostics
Home / Answers / Specialty & Lifting Equipment / Suspension and Driveline Tools

Suspension and Driveline Tools

Spring compressors, CV boot tools and other special tools for suspension and driveline repair.

3 answers · last reviewed 2026-11-16

How do I use a strut spring compressor safely?

Use a compressor rated for the spring, engage the hooks or jaws fully on opposite sides of the coils, compress evenly a little at a time, and never stand in line with the spring or use impact tools on a compressor not designed for them.

Read the full answer →

How do I install CV boot clamps correctly?

Short answer: Use the clamp type the boot kit specifies and the matching pliers, seat the boot in its groove, crimp or tension the clamp fully, and check that the boot does not twist when the joint moves.

CV boots are sealed with clamps that hold the boot onto the shaft and the joint housing. Common styles are ear-type clamps, which you crimp closed with an ear clamp plier, and earless or band clamps, which you tension and lock with a dedicated tool.

Before clamping, fill the joint with the grease amount included in the kit and seat the boot in its grooves. On some boots, you briefly lift the small end with a blunt tool to vent trapped air so the boot is not distorted. Install the clamp, crimp or tension it fully, and check that it cannot rotate.

Turn the axle through its range and confirm the boot does not twist or rub. Support the vehicle on a lift or rated stands, and never work under a vehicle supported only by a jack.

Tools used for this job

Lisle 30800 CV Boot Clamp Plier Ear TypeLisle 30500 CV Boot Clamp Plier Earless

Should brake lines use double flares or bubble flares?

Short answer: Use the flare type the vehicle maker specifies for that fitting; many domestic vehicles use double flares, while many imports use ISO bubble flares, and the two are not interchangeable.

Brake line fittings seal at the flare. A double flare, also called an inverted flare, folds the tube end back on itself for strength, and is common on many North American vehicles. An ISO or bubble flare forms a rounded end and is used on many European and Asian vehicles. Using the wrong flare means the fitting will not seal and may leak under pressure.

Identify the original flare and fitting before cutting the line. Use a flaring tool made for that flare type and tubing material, cut the tube square, deburr it, and slide the fitting on before flaring.

Pressure test the repair and bleed the brakes completely. Brake lines are safety critical: if you are unsure about the flare quality, make a new one. Support the vehicle safely, and road test only after the pedal feels firm.

Tools used for this job

Lisle 33260 3/16" & 1/4" Double Flaring ToolMastercool 72475-PRC Hydraulic Flaring Tool Kit

General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.