Store relaunching soon · pro diagnostics & tools for independent shopsjoseph@directtoolsource.com
Direct Tool SourcePro Diagnostics
Home / Answers / OBD-II & Trouble Codes / Engine Sensor and Timing Codes

Engine Sensor and Timing Codes

Camshaft, coolant temperature, oil pressure and variable valve timing codes.

23 answers · last reviewed 2026-11-16

What does P0463 fuel level sensor circuit high mean?

Short answer: The fuel level sensor signal voltage is higher than normal, often from an open circuit in the sender or its wiring, which can make the fuel gauge read empty or behave erratically.

The fuel level sensor in the tank is usually a variable resistor on a float arm. The computer or instrument cluster reads its signal. P0463 sets when the signal voltage stays above the normal range, often caused by an open circuit.

Check the connector at the fuel tank and the wiring for corrosion or damage. Measure the sender's resistance through its range when accessible, comparing with the specification. A worn spot on the sender can cause open readings at certain fuel levels.

Most repairs require dropping the tank or removing the fuel pump module. Relieve fuel pressure, keep sparks and flames away, work in a ventilated area, and support the tank properly.

Tools used for this job

Autel MS906MAX OBDII Bi-Directional Diagnostic ScannerFluke 1567573 TP40 Automotive Back Probe Pin Set

What does code P0014 mean?

P0014 means the exhaust camshaft on bank 1 is more advanced than the engine computer commanded, or the system is not performing as expected; oil level and condition, the oil control solenoid and timing components are common causes.

Read the full answer →

What does code P0107 mean?

P0107 means the manifold absolute pressure or barometric pressure sensor circuit voltage is lower than expected, often from wiring, connector or reference voltage problems, or a failed sensor.

Read the full answer →

What does code P0112 mean?

P0112 means the intake air temperature sensor circuit voltage is low, which the engine computer reads as a very hot air temperature; check for a shorted sensor or a signal wire shorted to ground.

Read the full answer →

What does code P0125 mean?

P0125 means the engine took too long to reach the temperature needed for closed loop fuel control, most often from a thermostat stuck open, low coolant or a coolant temperature sensor problem.

Read the full answer →

What does code P2263 mean?

P2263 means turbocharger or supercharger boost system performance is out of range; check for boost leaks, wastegate or actuator problems, and boost sensor readings.

Read the full answer →

What does code P0327 mean?

P0327 means the knock sensor 1 circuit on bank 1, or the single sensor, shows a low signal; common causes are damaged wiring, a poor connection or a failed sensor.

Read the full answer →

What does code P0017 mean?

P0017 means the engine computer sees a mismatch between crankshaft and exhaust camshaft position on bank 1, which can come from timing chain stretch, a jumped timing chain, phaser issues or sensor problems.

Read the full answer →

General guidance only. Follow the vehicle and tool manufacturer's procedures, and confirm vehicle coverage on the tool maker's list before buying.